Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
How to Determine the Temperature Measurement Point of Box-type Experimental Electric
05-28-2020, 12:51 PM,
Post: #1
How to Determine the Temperature Measurement Point of Box-type Experimental Electric
According to the size of the working area of the box furnace, the size of the temperature measurement frame is designed to determine 5 temperature measurement points and 1 monitoring point. Place the 5 temperature measurement points at the center point of the work area and the front lower left, front upper right, rear upper left, rear lower right at the four end corners (as shown in Figures 1, 2, 3, 4, and 5 above). The monitoring point is located in the working area where the extension direction of the thermocouple end point does not exceed 150mm. If the center point is no more than 150mm away from the temperature control thermocouple measurement point, the center point is regarded as the monitoring point.
Related products:
Vacuum Pump
Heat Treatment Guide,Heat Treatment Equipment
vacuum furnace
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)